PG&E’s success in Washington led to failure in San Bruno

August 31, 2011 - 1:34pm

Federal investigators from the National Transportation Safety Board concluded that the horrific gas pipeline explosion that killed 8 people in the Bay Area city of San Bruno was the result of a “litany of failures” by Pacific Gas and Electric.

Investigators charged PG&E with " poor record-keeping, inadequate inspection programs, and an integrity management program without integrity." According to internal PG&E documents and emails released in the investigation, PG&E had ample warning that the gas lines welds may have had dangerous flaws.     

PG&E was unprepared to respond to the disaster.  They didn’t have an emergency plan and relied on manual rather than automatic shutoff valves on the pipeline that resulted in the company taking 95 minutes to halt the flow of gas after the fire started. 

It’s now clear that PG&E could have done a much better job ensuring the integrity of their lines. They could have and should have done more and spent more to upgrade safety systems, maintain good records and conducted regular rigorous inspection of the 5,700  miles of pipes they operate.

Alongside their operational failures, PG&E and their industry allies could have done and spent a lot less lobbying to block stronger regulations that might very well have prevented the accidents in the first place.  PG&E spent nearly $100 million lobbying congress and federal regulatory agencies since 2006.

For years, PG&E and utility lobbyists have used a standard set of arguments to head off proposed safety regulations:  higher costs to consumers, impractical and rigid prescriptions, unnecessary rules, ‘one-size-fits-all’ regulations that don’t work.   If they weren’t reeling from the disaster today, they’d likely be calling new legislative proposals to strengthen pipeline protections “job killers.”  

PG & E lobbied aggressively – and successfully -- against several key safety proposals over the last decade.  

The National Transportation Safety Board has repeatedly made recommendations since 1969 calling for the use of automatic shut-off valves instead of manual valves to allow quicker shut down when a problem starts.  PG&E and industry lobbyists successfully blocked the recommendations every time claiming high costs and uncertain effectiveness.  A PG&E engineer wrote federal regulators that quicker shut down of gas “may give the public a false sense of security.”   

PG&E led a successful lobbying effort in 2003 to persuade federal regulators to endorse an inspection method that many experts deemed insufficient.  The “direct assessment” technique the utilities favored relies only on spot checks of the outside of pipes; not the inside, nor the welds that can fail.

They also fought proposals in 2003 that would have forced companies to report what inspection methods were using on pipelines. A spokesperson for the American Gas Association, a trade group representing PG&E and other distributors called the reporting requirements “unreasonable, illogical and of limited value.”

No one can be absolutely certain that these and other proposals would have prevented San Bruno disaster.  But there is wide agreement that they could have addressed some of PG&E’s critical failures and that could have saved lives.

PG&E’s opposition to pipeline safety standards followed a predictable pattern by industries that are asked to be responsible corporate actors to protect the public against health, safety and environmental dangers.    As happens after many accidents, legislators may now have little choice but to ignore industry rhetoric and pass legislation that will strengthen pipeline rules.    In the future however, after memories of the tragedy fade, we shouldn’t have to wait until lives are lost to pass new laws as industry goes back to claiming that health and safety proposals are “big government job killers.”    When that time comes, we should just stop listening and respond with Ronald Reagan’s famous phrase, “there they go again.”

Add new comment

Filtered HTML

  • Web page addresses and e-mail addresses turn into links automatically.
  • Allowed HTML tags: <a> <em> <strong> <cite> <blockquote> <code> <ul> <ol> <li> <dl> <dt> <dd>
  • Lines and paragraphs break automatically.

Plain text

  • No HTML tags allowed.
  • Web page addresses and e-mail addresses turn into links automatically.
  • Lines and paragraphs break automatically.